Mix Pack no. 5 - Red Pack - ProBand Fine Line Tape

$ 56.30

This tin comes with 5 tapes. Proband Fineline Red 1/16", 1/8", 1/4", and 1/2", plus one K-UTG 3/4" roll.

ProBand Fineline Red Extra Soft: for Solvent Paints 60 yd. Sizes in pack: 1/16", 1/8", 1/4", and 1/2"

ProBand Fineline Red is a new generation fine line tape, specifically designed for use with all waterborne paint systems including airbrush paints. ProBand Fineline Red also performs very well with low VOC, solvent based paints.

   Tech Info for Proband Fineline Red Tape
  • Adhesive base: Rubber crosslinked
  • Carrier: Stab. polymer film
  • Elongation: 220%
  • Temp. resistance 1h/130°C (266°F)
  • UV-resistance: Limited
  • Waterborne resistance: Excellent
  • Ridgidness: Extra soft

K-UTG 3/4" x 55 yrds

An extremely thin, flexible, semi-translucent tape with heat & UV resistant acrylic adhesive. This tape can be lifted and repositioned without leaving any residue. Ideal for work on difficult surfaces, two-toning, color separation, and airbrushing.

   Tech Info for K-UTG

  • Adhesive base: Acrylic
  • Carrier: Stab. special paper
  • Elongation: 4%
  • Temp. resistance 1h/100°C (212°F)
  • UV-resistance: Up to 6 months
  • Waterborne resistance: Excellent

Tech Tips:

1. Pull enough tape off the roll to work with, do not move your guide finger while unrolling. (This will keep the tape’s width consistent without over-stretching.)
2. In tight turns, finesse it through the curves, let it flow by itself. (It will easily wrap around the edges and contours.)
3. Be careful not to ”nick the edges” while laying out design. When cutting though, apply light force. (It is softer than other fineline tapes allowing for the perfect cut.)
4. Always seal the edges. (This will prevent paint seepage, bleed through.)
5. Apply the tape at ambient (68°- 78°F / 21°- 24°C) temperature. (Extreme cold will shrink it, extreme heat will expand it.)